Published · Updated · 7 min read
Most Common BYD SEALION Body Parts Needed After Collision Repair
Typical BYD SEALION body parts needed after front, side and rear impacts, from bumper covers and brackets to radiators and sensors, and how to order them.
Most collision repairs on SEALION-family cars need more than the visible panel. Behind a cracked bumper there are usually broken brackets, a pushed-in absorber and often a damaged sensor or cooling part.
Which parts are typically needed after a front-end impact?
The front end packs a lot into a small space. On the SEALION 6, the SEALION 7 and the SEAL U, the bumper, lights, cooling parts and driver-assistance sensors all sit in the impact zone. A low-speed hit can reach well beyond the bumper cover. The table below follows the typical repair pattern, from the outside in.
| Part | Why it is often needed | Note |
|---|---|---|
| Front bumper cover | Takes the first contact | Ships in primer; EV and DM-i versions differ |
| Bumper brackets, guides and clips | Break when the cover is pushed in | Cheap, but decide whether the bumper fits flush |
| Bumper beam and energy absorber | Deform to absorb the impact | Replace if deformed |
| Lower grilles and intake trims | Crack easily | Design differs by version |
| Headlights | Mounting tabs break | A repair bracket may be enough |
| Fog and reflector lamps | Mounted in the bumper | Check after any low impact |
| Radiator, condenser and cooling fan | Sit right behind the bumper | Check hoses and brackets too |
| Parking sensors and radar bracket | Mounted in or behind the bumper | Calibration needed after replacement |
| Hood and front fenders | Bend in harder impacts | Ship in primer |
| Wheel-arch liners | Tear when the fender moves | Separate parts from the fender |
| Washer bottle, pump and lines | Packed into the front corner | Easy to miss until refilling |
What about side impacts?
Side damage is mostly about doors and the parts fixed to them. Each door position is its own part, so state front or rear, left or right.
- Door shells, door mouldings and lower door trims.
- Exterior door handles, including the flush, motorised handles on the SEALION 7.
- Side mirror, or just its glass, cap or turn-signal lamp.
- Window regulators, seals and weatherstrips.
- Side skirts and wheel-arch trims.
- Hinges and door checks if the door was forced.
What is usually replaced after a rear impact?
A rear hit typically needs the rear bumper cover, its lower trims and diffuser, the brackets and the rear beam. Tail-light sections are often cracked; on the SEALION 7, the full-width light bar is split into body and tailgate sections, so only the damaged section may need replacing. Check the tailgate shell, its struts, the high-mounted brake light and any reversing camera or rear parking sensors.
How do you order collision parts without a second shipment?
- Send the VIN first. It separates the EV and DM-i versions and the trim.
- Take photos of the damage from two angles: one front-on, one from the side.
- Strip the bumper before ordering if you can. Hidden brackets and absorbers show up then.
- List clips, brackets and fixings with the panels. They are small, but a missing clip can hold up the whole job.
- Say which panels you need in primer. Body panels ship unpainted so your shop can match the colour.
The parts that delay repairs are rarely the big panels. They are the brackets, clips and liners nobody listed. Order them with the bumper and we ship everything together.
What has to happen after the parts are fitted?
If the car has front radar or surround-view cameras, the workshop should check calibration after replacing a bumper, a radar bracket or a mirror. The panels themselves arrive in primer and need painting at your shop. Cooling parts need refilling with the coolant specification for your version. We send photos of the parts and packing before dispatch, so you can check the order against your list.
Bumper covers, beams, brackets and sensor holdersFront and rear bumper parts for the SEALION 6, SEALION 7 and SEAL U.Radiators, condensers and cooling fansCooling parts that sit in the front impact zone, matched for EV or DM-i.SEALION 6 front bumper parts, piece by pieceA closer look at the cover, brackets, beam and trims behind the front bumper.Send us the VIN and photos of the damage, and we will build the full parts list for the repair.
Talk directly to the parts desk
Send a part list, a VIN or a photo. We answer with fitment, price and shipping.